Rayman Pirate-Community

how do you submit?

Here's mine if I'm late.

Same image resized to 300 x 100
Something went wrong tho and I chose the wrong type of file so it isn't transparent :/

SrRayman wrote: Wed Nov 28, 2018 3:46 am how do you submit?

You just have to submit a post with your signature on it, and as long as it meets the requirements for width and height, you're good to go!
Though make sure you upload your sig as an attachment and not as an image from a third-party site.

I thought he was joking because well, he submit a sig while asking.

As for the deadline, Plum has stated in his post that it's the 17th.

I'll just submit this one I made while I'm here.

Here's a better version that meets height standards.

It meets standards so long as it's at least 200 pixels wide, but no wider than 750, then at least 100 pixels tall but no taller than 285.

That means that unfortunately, your new one is 35 pixels taller than it should be.

Edit: Your original one would be ok if it was 200 in width instead of 148.

AHHHHHHHHHHHH!
I seriously don't like going back to the dumb app I use to make that simple thing but I might as well do it to submit again.
EEEEEE

Here, this one meets standards
Or this version new one you made:

Oh... Okay then oof. I literally ran to make this one.

That one's only 180 pixels wide. I also can't accept the ones Steo made for you since that would violate the one-entry-per-person rule. What app are you using?

Do you not have access to a non-web-based image editor?

If you have no option but to use that editor, then just go to image and make sure canvas size is set to least 200 wide and 100 tall. Make sure you click the centre box so it resizes with the image on the centre.

I agree that a non web based editor would be a lot easier to work with, but that should do the job for now.

EDIT: I mean click the middle box where it says "anchor" before resizing.

Here it is!

Just to let you know, from the first page the rule is:

Signatures CANNOT be smaller than the following size: 200 pixels (width) by 100 pixels (height). Also they CANNOT be larger than 750 pixels (width) by 285 pixels (height)

So that one is allowed, but you could make it bigger if you wanted to, so long as it's not any smaller than 200x100 or any larger than 750x285. It basically just has to be between 200-750 in width while being between 100-285 in height to be eligible for entry.

Your first image was 52px too small in width and your second one was 35px too tall.

After making all those submissions, here is the final one.

Such an aspect ratio is highly unorthodox, but let's just go with it!

Count me in!

Nice.

Nice entries, guys! Still don't have an idea myself.

#Rubber mark# wrote: Tue Dec 04, 2018 12:47 pm Nice entries, guys! Still don't have an idea myself.

Do you have one now?